Product Documentation

Configuring SNMP Trap Forwarding

Apr 02, 2015
You can configure Command Center to receive traps on an available port and forward them to any device. You can set the default values for the destination that receives the trap, the port number of the destination device, and the community to which the device belongs.

To configure SNMP trap forwarding

  1. On the Administration tab, in the right pane, under Settings, click Trap Forward Settings.
  2. Configure the following:
    1. Trap Destination: Specify the IP address of the device that receives the forwarded SNMP trap.
    2. Destination Port: Specify the port number of the device that receives the forwarded SNMP trap.
    3. Trap Community: Specify the community string of the trap receiver.
  3. Click OK.