Arctera

VVR IPv6 software limitations

VVR does not support the following Internet Protocol configurations:

  • A replication configuration from an IPv4-only node to an IPv6-only node and from an IPv6-only node to an IPv4-only node is not supported, because the IPv6-only node has no IPv4 address configured on it and therefore VVR cannot establish communication between the two nodes.
  • A replication configuration in which an IPv4 address is specified for the local_host attribute of a primary RLINK and an IPv6 address is specified for the remote_host attribute of the same RLINK.
  • A replication configuration in which an IPv6 address is specified for the local_host attribute of a primary RLINK and an IPv4 address is specified for the remote_host attribute of the same RLINK.
  • IPv6 is not supported in a CVM and VVR cluster where some nodes in the cluster are IPv4-only and other nodes in the same cluster are IPv6-only, or all nodes of a cluster are IPv4-only and all nodes of a remote cluster are IPv6-only.
  • VVR does not support Edge and NAT-PT routers that facilitate IPv4 and IPv6 address translation.
VVR IPv6 software limitations

In this article