Citrix ADC

Viewing the traffic rate

September 21, 2020

Contributed by:

S S

If traffic through one or more virtual servers matches a rate-based policy, you can view the rate of this traffic. The rate statistics are maintained in the limit identifier that you named in the rule for the rate-based policy. If more than one policy uses the same limit identifier, you can view the traffic rate as defined by hits to all of the policies that use the particular limit identifier.

To view the traffic rate by using the command line interface

At the command prompt, type the following command to view the traffic rate:

show ns limitSessions <limitIdentifier>
<!--NeedCopy-->

Example:

sh limitsession myLimitSession
<!--NeedCopy-->

To view the traffic rate by using the configuration utility

Navigate to AppExpert > Rate Limiting > Limit Identifiers.
Select a limit identifier whose traffic rate you want to view.
Click the Show Sessions button. If traffic through one or more virtual servers has matched a rate limiting policy that uses this limit identifier (and the hits are within the configured time slice for this identifier), the Session Details dialog box appears. Otherwise, you receive a “No session exists” message.

The official version of this content is in English. Some of the Cloud Software Group documentation content is machine translated for your convenience only. Cloud Software Group has no control over machine-translated content, which may contain errors, inaccuracies or unsuitable language. No warranty of any kind, either expressed or implied, is made as to the accuracy, reliability, suitability, or correctness of any translations made from the English original into any other language, or that your Cloud Software Group product or service conforms to any machine translated content, and any warranty provided under the applicable end user license agreement or terms of service, or any other agreement with Cloud Software Group, that the product or service conforms with any documentation shall not apply to the extent that such documentation has been machine translated. Cloud Software Group will not be held responsible for any damage or issues that may arise from using machine-translated content.

Viewing the traffic rate

September 21, 2020

Contributed by:

S S

September 21, 2020

Contributed by:

S S

Viewing the traffic rate

To view the traffic rate by using the command line interface

To view the traffic rate by using the configuration utility

In this article