ADC

Enable priority queuing

September 21, 2020

Contributed by:

To use the priority queuing feature the Citrix ADC appliance, you must first enable it.

Enable priority queuing by using the CLI

At the command prompt, type the following commands to enable priority queuing and verify the configuration:

-  enable ns feature PriorityQueuing
-  show ns feature  
<!--NeedCopy-->

Example:

> enable ns feature PriorityQueuing
 Done
> show ns feature

        Feature                        Acronym              Status
        -------                        -------              ------
 1)     Web Logging                    WL                   ON
 2)     Surge Protection               SP                   OFF
 3)     Load Balancing                 LB                   ON
 .
 .
 .
 8)     Priority Queuing               PQ                   ON
 .
 23)    HTML Injection                 HTMLInjection        ON
 24)    Citrix ADC Push                 push                 OFF
 Done
<!--NeedCopy-->

Enable priority queuing by using the GUI

Navigate to System > Settings.
In the details pane, click Configure advanced features.
In the Configure Advanced Features dialog box, select the Priority Queuing check box.
Click OK.

The official version of this content is in English. Some of the Cloud Software Group documentation content is machine translated for your convenience only. Cloud Software Group has no control over machine-translated content, which may contain errors, inaccuracies or unsuitable language. No warranty of any kind, either expressed or implied, is made as to the accuracy, reliability, suitability, or correctness of any translations made from the English original into any other language, or that your Cloud Software Group product or service conforms to any machine translated content, and any warranty provided under the applicable end user license agreement or terms of service, or any other agreement with Cloud Software Group, that the product or service conforms with any documentation shall not apply to the extent that such documentation has been machine translated. Cloud Software Group will not be held responsible for any damage or issues that may arise from using machine-translated content.

Enable priority queuing

September 21, 2020

Contributed by:

September 21, 2020

Contributed by:

Enable priority queuing

Enable priority queuing by using the CLI

Enable priority queuing by using the GUI

In this article