Citrix ADC

Synchronizing time across cluster nodes

December 21, 2020

Contributed by:

C S

The cluster uses a Precision Time Protocol (PTP) to synchronize the time across cluster nodes. PTP uses multicast packets to synchronize the time. If there are some issues in time synchronization, you must disable PTP and configure Network Time Protocol (NTP) on the cluster.

To enable/disable PTP by using the command line interface

At the command prompt of the cluster IP address, type:

set ptp -state disable

To enable/disable PTP by using the configuration utility

Log on to the cluster IP address.
Navigate to System > Cluster.
In the details pane, under Utilities, click Configure PTP Settings.
In the Enable/Disable PTP dialog box, select whether you want to enable or disable PTP.
Click OK.

The official version of this content is in English. Some of the Cloud Software Group documentation content is machine translated for your convenience only. Cloud Software Group has no control over machine-translated content, which may contain errors, inaccuracies or unsuitable language. No warranty of any kind, either expressed or implied, is made as to the accuracy, reliability, suitability, or correctness of any translations made from the English original into any other language, or that your Cloud Software Group product or service conforms to any machine translated content, and any warranty provided under the applicable end user license agreement or terms of service, or any other agreement with Cloud Software Group, that the product or service conforms with any documentation shall not apply to the extent that such documentation has been machine translated. Cloud Software Group will not be held responsible for any damage or issues that may arise from using machine-translated content.

Was this helpful

Synchronizing time across cluster nodes

December 21, 2020

Contributed by:

C S

December 21, 2020

Contributed by:

C S

Synchronizing time across cluster nodes

To enable/disable PTP by using the command line interface

To enable/disable PTP by using the configuration utility

In this article