ADC

Use Case: ECMP with BGP routing

To configure ECMP with BGP routing protocol, perform the following steps:

  1. Log on to the cluster IP address.

  2. Enable BGP routing protocol.

    > enable ns feature bgp
    
  3. Add VLAN and bind the required interfaces.

    > add vlan 985
    > bind vlan 985 -ifnum 0/0/1 1/0/1
    
  4. Add the spotted IP address and bind them to the VLAN.

    > add ns ip 10.100.26.14 255.255.255.0 -ownerNode 1 -dynamicRouting ENABLED
    > add ns ip 10.100.26.15 255.255.255.0 -ownerNode 2 -dynamicRouting ENABLED
    > bind vlan 985 -ipAddress 10.100.26.10 255.255.255.0
    
  5. Configure BGP routing protocol on ZebOS using the VTYSH shell.

    > vtysh conf t router bgp 65535 neighbor 10.100.26.1 remote-as 65535
    
  6. Configure BGP on the external switch. The following sample configurations are provided for the Cisco® Nexus 7000 C7010 Release 5.2(1) switch. Similar configurations must be performed on other switches.

    > router bgp 65535 no synchronization
      bgp log-neighbor-changes neighbor 10.100.26.14 remote-as 65535 neighbor 10.100.26.15 remote-as 65535 no auto-summary
      dont-capability-negotiate
      dont-capability-negotiate
      no dynamic-capability
    
Use Case: ECMP with BGP routing

In this article