ADC

Configure SSLv2 redirection

December 23, 2020

Contributed by:

S S

To initiate an SSL transaction and for successful completion of the SSL handshake, the server and the client must agree on an SSL protocol that both support. If the SSL protocol version supported by the client is not acceptable to the server, the server does not go ahead with the transaction. An error message is displayed.

You can configure the server to display a precise error message (user-configured or internally generated) advising the client on the next action to be taken. Configuring the server to display this message requires that you set up SSLv2 redirection.

Configure SSLv2 redirection by using the CLI

At the command prompt, type the following commands to configure SSLv2 redirection and verify the configuration:

-  set ssl vserver <vServerName> [-sslv2Redirect ( ENABLED | DISABLED ) [-sslv2URL <URL>]]
-  show ssl vserver <vServerName>
<!--NeedCopy-->

Example:

set ssl vserver vs-ssl -sslv2Redirect ENABLED -sslv2URL http://sslv2URL
Done

show ssl vserver vs-ssl

        Advanced SSL configuration for VServer vs-ssl:
        DH: DISABLED
        Ephemeral RSA: ENABLED          Refresh Count: 1000
        Session Reuse: ENABLED          Timeout: 600 seconds
        Cipher Redirect: DISABLED
        SSLv2 Redirect: ENABLED Redirect URL: http://sslv2URL
        ClearText Port: 0
        Client Auth: DISABLED
        SSL Redirect: DISABLED
        Non FIPS Ciphers: DISABLED
        SNI: DISABLED
        OCSP Stapling: DISABLED
        HSTS: DISABLED
        HSTS IncludeSubDomains: NO
        HSTS Max-Age: 0
        SSLv2: DISABLED SSLv3: ENABLED  TLSv1.0: ENABLED TLSv1.2: ENABLED  TLSv1.2: ENABLED

1)      CertKey Name: Auth-Cert-1       Server Certificate

1)      Cipher Name: DEFAULT
        Description: Predefined Cipher Alias
Done
<!--NeedCopy-->

Configure SSLv2 redirection by using the GUI

Navigate to Traffic Management > Load Balancing > Virtual Servers, and open a virtual server.
In the SSL Parameters section, select SSLv2 Redirect, and specify a URL.

The official version of this content is in English. Some of the Cloud Software Group documentation content is machine translated for your convenience only. Cloud Software Group has no control over machine-translated content, which may contain errors, inaccuracies or unsuitable language. No warranty of any kind, either expressed or implied, is made as to the accuracy, reliability, suitability, or correctness of any translations made from the English original into any other language, or that your Cloud Software Group product or service conforms to any machine translated content, and any warranty provided under the applicable end user license agreement or terms of service, or any other agreement with Cloud Software Group, that the product or service conforms with any documentation shall not apply to the extent that such documentation has been machine translated. Cloud Software Group will not be held responsible for any damage or issues that may arise from using machine-translated content.

Was this helpful

Configure SSLv2 redirection

December 23, 2020

Contributed by:

S S

December 23, 2020

Contributed by:

S S

Configure SSLv2 redirection

Configure SSLv2 redirection by using the CLI

Configure SSLv2 redirection by using the GUI

In this article