Citrix ADC MPX

Citrix ADC MPX 26000-50S

The Citrix ADC MPX 26000-50S appliances are 2U appliances. These appliances have two 14-core processors and 256 GB of memory. The appliances have four 50G and 16 25G network ports.

For information about the software releases supported on the Citrix ADC hardware platforms, see Citrix ADC MPX hardware software compatibility matrix.

The following figure shows the front panel of the Citrix ADC MPX 26000-50S appliances.

Figure 1. Citrix ADC MPX 26000-50S, front panel

MPX 26000-50S front panel

The Citrix ADC MPX 26000-50S appliances have the following ports:

  • RS232 serial console port.
  • One 10/100/1000Base-T RJ45 copper Ethernet LOM Port. Use this port to remotely monitor and manage the appliance independently of the Citrix ADC software.
  • Two 10/100/1000Base-T RJ45 copper Ethernet Management Ports, numbered 0/1 and 0/2. These ports are used to connect directly to the appliance for Citrix ADC administration functions.
  • Four 50G ports, numbered 50/1 to 50/4.
  • Sixteen 25G ports, numbered 25/1 through 25/16.

The following figure shows the back panel of the MPX 26000-50S appliances.

Figure 2. Citrix ADC MPX 26000-50S, back panel

MPX 26000-50S back panel

The following components are visible on the back panel of the Citrix ADC MPX 26000-50S appliances:

  • Two 480 GB or larger removable solid-state drives in a redundant array of independent disks (RAID) configuration. In a RAID configuration, the same data is stored on multiple drives to improve performance, increase storage capacity, lower the risk of data loss, and provide fault tolerance. The two SSDs store the same data. If one fails and you replace it, the new SSD mirrors the other one.

    Note: Drive densities might increase as components become EOL but its size is never smaller than the original.

  • Power switch, which turns power to the appliance on or off.
    • If the OS is functional, press the switch for less than two seconds to power down the system with a graceful shutdown.
    • If the OS is not responsive, press the power switch for more than 4 seconds to force the power off.
  • Two hot-swappable 100–240 VAC, 1200 W power supply modules. Max power consumption is 764 W. Typical power consumption is 628 W. Each power supply has an LED indicating its status:
LED Color LED Indicates
OFF No power to any power supply on the appliance.
Flashing RED No power to this power supply.
Flashing GREEN Power supply is in standby mode.
GREEN Power supply is functional.
RED Power supply failure.
Flashing RED and GREEN Warning; (OVP/UVP/OCP/OTP/Fan); OVP = Over Voltage Protection; UVP = Under Voltage Protection; OCP = Over Current Protection; OTP = Over Temperature Protection; OTP = Over Temperature Protection
  • Disable alarm button. Press this button to silence the power alarm when one of two power supplies loses input power or when a power supply is malfunctioning.  
  • Non-Maskable Interrupt (NMI) Button, used at the request of Technical Support to initiate a core dump. To press this red button, which is recessed to prevent unintentional activation, use a pen, pencil, or other pointed object. The NMI Button is also available remotely over the network in the LOM GUI, in the Remote Control menu. For more information about the lights out management port of the appliance, see Lights out management port of the Citrix ADC MPX appliance.
Citrix ADC MPX 26000-50S