Citrix ADC MPX 14000 FIPS
Note For information about configuring a Citrix ADC MPX 14030/14060/14080 FIPS appliance, see Configuring the MPX 14000 FIPS appliance topic.
The Citrix ADC models MPX 14030 FIPS, MPX 14060 FIPS, and MPX 14080 FIPS are 2U appliances. Each model has two 6-core processors, 64 GB of memory, sixteen 10G SFP+ ports (16x10G SFP+).
The following figure shows the front panel of the MPX 14030/14060/14080 FIPS appliances.
Figure 1. Citrix ADC MPX 14030/14060/14080 FIPS, front panel
The Citrix ADC MPX 14030/14060/14080 FIPS appliances have the following ports:
- RS232 serial Console Port.
- 10/100Base-T copper Ethernet Port (RJ45), also called the LOM port. You can use this port to remotely monitor and manage the appliance independently of the Citrix ADC software.
- Two 10/100/1000Base-T copper Ethernet Management Ports (RJ45), numbered 0/1 and 0/2 from left to right. These ports are used to connect directly to the appliance for system administration functions.
- Sixteen 10G SFP+ ports.
- USB port (reserved for a future release).
- 10G ports do not support 1G copper or 1G fiber transceivers.
- 40G ports do not support 10G and 1G transceivers.
The following figure shows the back panel of the MPX 14030/14060/14080 FIPS appliances.
Figure 2. Citrix ADC MPX 14030/14060/14080 FIPS appliance, back panel
The following components are visible on the back panel of the MPX 14000 FIPS appliance:
Two 300 GB or larger removable solid-state drives in a redundant array of independent disks (RAID) devices. In a RAID configuration, the same data is stored on multiple drives to improve performance, increase storage capacity, lower the risk of data loss, and provide fault tolerance. The two SSDs store the same data. If one fails and you replace it, the new SSD mirrors the other one.
Note: Drive densities might increase as components become EOL but its size is never smaller than the original.
- Power switch. This switch turns the power to the appliance on or off. Press the switch for less than two seconds to shut off the power.
- Two power supplies. Each power supply is rated at 1000 watts, 100–240 volts. Each power supply has an LED that indicates the status of the power supply, as described in Common hardware components.
Disable alarm button. This button is functional only when the appliance has two power supplies. Press this button to stop the power alarm from sounding when:
- You have plugged the appliance into only one power outlet
- One power supply is malfunctioning and you want to continue operating the appliance until it is repaired.
- Non-maskable interrupt (NMI) button. This button is used at the request of Technical Support to initiate a core dump. To press this red button, which is recessed to prevent unintentional activation, use a pen, pencil, or other pointed object. The NMI Button is also available remotely over the network in the LOM GUI, in the Remote Control menu. For more information about the lights out management port of the appliance, see Lights out management port of the Citrix ADC MPX appliance.