-
-
Citrix ADC SDX 11500, SDX 13500, SDX 14500, SDX 16500, SDX 18500, and SDX 20500
-
Citrix ADC SDX 11515, SDX 11520, SDX 11530, SDX 11540, and SDX 11542
-
Citrix ADC SDX 14020, SDX 14030, SDX 14040, SDX 14060, SDX 14080 and SDX 14100
-
Citrix ADC SDX 14020-40G, SDX 14040-40G, SDX 14060-40G, SDX 14080-40G and SDX 14100-40G
-
Citrix ADC SDX 14040-40S, SDX 14060-40S, SDX 14080-40S and SDX 14100-40S
-
Citrix ADC SDX 22040, SDX 22060, SDX 22080, SDX 22100, and SDX 22120
-
Lights out management port of the Citrix ADC SDX appliance
-
Obtaining the MAC address, serial number, and host properties of the appliance
-
Specifying the port for IPMI BMC failover
-
Fortville NICs firmware upgrade on Citrix ADC SDX appliances
-
Converting a Citrix ADC MPX appliance to a Citrix ADC SDX appliance
This content has been machine translated dynamically.
Dieser Inhalt ist eine maschinelle Übersetzung, die dynamisch erstellt wurde. (Haftungsausschluss)
Cet article a été traduit automatiquement de manière dynamique. (Clause de non responsabilité)
Este artículo lo ha traducido una máquina de forma dinámica. (Aviso legal)
此内容已动态机器翻译。 放弃
このコンテンツは動的に機械翻訳されています。免責事項
This content has been machine translated dynamically.
This content has been machine translated dynamically.
This content has been machine translated dynamically.
This article has been machine translated.
Dieser Artikel wurde maschinell übersetzt. (Haftungsausschluss)
Ce article a été traduit automatiquement. (Clause de non responsabilité)
Este artículo ha sido traducido automáticamente. (Aviso legal)
この記事は機械翻訳されています.免責事項
이 기사는 기계 번역되었습니다.
Este artigo foi traduzido automaticamente.
这篇文章已经过机器翻译.放弃
Translation failed!
Specifying the port for IPMI BMC failover
With LOM firmware version 3.x or later, the default mode for failover between the dedicated LOM port and the shared LOM/management port is to fail over to the active port. By default, no user configuration is needed other than selecting the port to which to connect the cable. The motherboard has an Ethernet switch between the management MAC and the management port, and between the LOM MAC and the LOM port. The following figure shows the Ethernet switch.
Figure 1. Ethernet Switch
You can set this switch to direct LOM traffic through the dedicated LOM port or through the shared management port. A dedicated LOM port removes the management port as a single point of failure, while a shared LOM/management port reduces the cabling costs.
Share
Share
In this article
This Preview product documentation is Citrix Confidential.
You agree to hold this documentation confidential pursuant to the terms of your Citrix Beta/Tech Preview Agreement.
The development, release and timing of any features or functionality described in the Preview documentation remains at our sole discretion and are subject to change without notice or consultation.
The documentation is for informational purposes only and is not a commitment, promise or legal obligation to deliver any material, code or functionality and should not be relied upon in making Citrix product purchase decisions.
If you do not agree, select Do Not Agree to exit.