XenCenter

Add a Virtual Network Interface

March 14, 2024

Contributed by:

Note:

XenCenter YYYY.x.x is not yet supported for use with Citrix Hypervisor 8.2 CU1 in production environments. To manage your Citrix Hypervisor 8.2 CU1 production environment, use XenCenter 8.2.7. For more information, see the XenCenter 8.2.7 documentation.

You can install XenCenter 8.2.7 and XenCenter YYYY.x.x on the same system. Installing XenCenter YYYY.x.x does not overwrite your XenCenter 8.2.7 installation.

You can add up to seven Virtual Network Interfaces (VNIs) for a VM. For more information about the maximum number of VNIs supported for a VM, see the XenServer Configuration Limits.

Open the Add Virtual Interface dialog box by doing one of the following:
- Select the VM in the Resources pane. Go to the Networking tab. Click Add Interface.
- On the Network page of the New VM wizard, click Add.
Select a network location from the Network list.
Specify the MAC address.
- To use a generated MAC address, select Auto-generate a MAC address.
- To explicitly enter a MAC address, select Use this MAC address. Enter an address in the form XY:XX:XX:XX:XX:XX where X is any hexadecimal digit, and Y is one of 2, 6, A or E.
To set an optional I/O priority Quality of Service (QoS) setting for maximum network transfer rate, select the check box and enter a value in kilobytes per second (kB/s).
Click Add.

The official version of this content is in English. Some of the Cloud Software Group documentation content is machine translated for your convenience only. Cloud Software Group has no control over machine-translated content, which may contain errors, inaccuracies or unsuitable language. No warranty of any kind, either expressed or implied, is made as to the accuracy, reliability, suitability, or correctness of any translations made from the English original into any other language, or that your Cloud Software Group product or service conforms to any machine translated content, and any warranty provided under the applicable end user license agreement or terms of service, or any other agreement with Cloud Software Group, that the product or service conforms with any documentation shall not apply to the extent that such documentation has been machine translated. Cloud Software Group will not be held responsible for any damage or issues that may arise from using machine-translated content.

Was this helpful

Add a Virtual Network Interface

March 14, 2024

Contributed by:

March 14, 2024

Contributed by:

Add a Virtual Network Interface

In this article