Citrix SD-WAN Platforms

Port Parameters

Each bridge and motherboard port can be:

  • Enabled or disabled
  • Assigned an IP address and subnet mask
  • Assigned a default gateway
  • Assigned to a VLAN
  • Set to 1000 Mbps, 100 Mbps, or 10 Mbps
  • Set to full duplex, half-duplex, or auto (on SD-WAN 4000 WAN OP/SE/ 5000 WAN OP appliances, some ports can be set to 10 Gbps)

All of these parameters except the speed/duplex setting are set on the Configuration > IP Address page. The speed/duplex settings are set on the Configuration > Interface page.

Notes about parameters:

  • Disabled ports do not respond to any traffic.
  • The browser-based UI can be enabled or disabled independently on all ports.
  • To secure the UI on ports with IP addresses, select HTTPS instead of HTTP on the Configuration: Administrator Interface: Web Access page.
  • Inline mode works even if a bridge has no IP address. All other modes require that an IP address be assigned to the port.
  • Traffic is not routed between interfaces. For example, a connection on bridge apA does not cross over to the Primary or Aux1 ports, but remains on bridge apA. All routing issues are left to your routers.
Port Parameters

In this article