Citrix SD-WAN Platforms

Installing the Appliance

After you have determined that the location where you will install your appliance meets the environmental standards and the server rack is in place according to the instructions, you are ready to install the hardware. After you mount the appliance, you are ready to connect it to the network, to a power source, and to the console terminal that you will use for initial configuration. You can also connect the appliance to a computer through Ethernet port for initial configuration. On SD-WAN 1000-SE appliance, this port is labeled as MGMT (management) port and on SD-WAN 2000-SE and SD-WAN 2100-SE appliances, the port is labeled as PRI (primary) port. To complete the installation, you switch on the appliance. Be sure to observe the cautions and warnings listed with the installation instructions.

For more information, see Configure Management IP Address.

Installing the Appliance

In this article