Citrix SD-WAN Platforms

Initial Configuration

May 23, 2019

Contributed by:

The appliance shipped from Citrix has default IP addresses configured on it. To deploy the appliance on the network, you must configure the appropriate IP addresses on the appliance to accelerate the network traffic.

To perform initial configuration:

Identify the prerequisites for the initial configuration.
Record various values required in the initial configuration procedure.
Configure the appliance by connecting it to the Ethernet port.
Perform additional configuration for Windows.
Assign management IP address through the serial console.
Troubleshoot initial configuration issues.

By default, the initial configuration deploys the appliance in inline mode. If you are configuring a hardware SD-WAN appliance, physically connect the appliance to a PC. Refer to the following link; configuring SD-WAN hardware

The official version of this content is in English. Some of the Cloud Software Group documentation content is machine translated for your convenience only. Cloud Software Group has no control over machine-translated content, which may contain errors, inaccuracies or unsuitable language. No warranty of any kind, either expressed or implied, is made as to the accuracy, reliability, suitability, or correctness of any translations made from the English original into any other language, or that your Cloud Software Group product or service conforms to any machine translated content, and any warranty provided under the applicable end user license agreement or terms of service, or any other agreement with Cloud Software Group, that the product or service conforms with any documentation shall not apply to the extent that such documentation has been machine translated. Cloud Software Group will not be held responsible for any damage or issues that may arise from using machine-translated content.

Was this helpful

Initial Configuration

May 23, 2019

Contributed by:

May 23, 2019

Contributed by:

Initial Configuration

In this article