The NetScaler and
CloudBridge virtual machines
are hosted on the hard-disk drive.
Replacing a Hard
Verify that the replacement hard disk drive is the correct type
for the CloudBridge
To install a
hard disk drive
Shut down the appliance.
Locate the hard disk drive
on the back panel of the appliance.
Disengage the hard disk
drive by pushing the safety latch of the drive cover to the right or down, depending on the platform, while pulling out on the drive handle to disengage. Pull out the faulty drive.
Figure 1. Removing the Existing Hard Disk Drive
Pick up the new disk drive,
open the drive handle fully to the left, and insert the new drive into the slot
as far as possible. To seat the drive, close the handle flush with the rear of
the appliance so that the hard drive locks securely into the slot.
Important: When you insert the drive, make sure that the Citrix product
label is at the top.
Figure 2. Inserting the Replacement Hard Disk Drive