can be installed in standard server racks that conform to EIA-310-D
specification. The appliances ship with a set of rails, which you must install
before you mount the appliance. The only tools that you need for installing an
appliance are a Phillips screwdriver and a flathead screwdriver.
Caution: If you are installing the appliance as the only unit in the
rack, mount it at the bottom. If the rack contains other units, make sure that
the heaviest unit is at the bottom. If the rack has stabilizing devices
available, install them before mounting the appliance.
4000/5000 appliance requires two rack
ships with a mounting rail kit that contains two rail assemblies, one for the
left side and the other for the right side of the appliance, and screws to
attach the rails. An assembly consists of an inner rail and a rack rail. The
supplied rail kit is 28 inches long (38 inches extended). Contact your Citrix
sales representative to order a 23-inch (33 inches extended) rail kit.
Note: The same
rail kit is used for both square-hole and round-hole racks. See figure 4 for specific instructions for threaded, round-hole
To mount the
appliance, you must first install the rails and then install the appliance in
following tasks to mount the appliance:
- Remove the inner rails
from the rail assembly.
- Attach the inner rails to
- Install the rack rails on
- Install the appliance in