NetScaler Gateway

Configuring Auto Negotiation

October 5, 2020

Contributed by:

S C

By default, the appliance is configured to use auto negotiation, in which NetScaler Gateway transmits network traffic both directions simultaneously and determines the appropriate adapter speed. If you leave the default setting to Auto Negotiation, NetScaler Gateway uses full-duplex operation, in which the network adapter is capable of sending data in both directions simultaneously.

If you disable auto negotiation, NetScaler Gateway uses half-duplex operation, in which the adapter can send data in both directions between two nodes, but the adapter can only use one direction or the other at a time.

For first time installation, Citrix recommends that you configure NetScaler Gateway to use auto negotiation for ports that are connected to the appliance. After you log on initially and configure NetScaler Gateway, you can disable auto negotiation. You cannot configure auto negotiation globally. You must enable or disable the setting for each interface.

To enable or disable auto negotiation

In the configuration utility, on the Configuration tab, in the navigation pane, expand System > Network and then click Interfaces.
In the details pane, select the interface and then click Open.
Do one of the following in the Configure Interface dialog box:
- To enable auto negotiation, click Yes next to Auto Negotiation and then click OK.
- To disable auto negotiation, click No next to Auto Negotiation and then click OK.

The official version of this content is in English. Some of the Citrix documentation content is machine translated for your convenience only. Citrix has no control over machine-translated content, which may contain errors, inaccuracies or unsuitable language. No warranty of any kind, either expressed or implied, is made as to the accuracy, reliability, suitability, or correctness of any translations made from the English original into any other language, or that your Citrix product or service conforms to any machine translated content, and any warranty provided under the applicable end user license agreement or terms of service, or any other agreement with Citrix, that the product or service conforms with any documentation shall not apply to the extent that such documentation has been machine translated. Citrix will not be held responsible for any damage or issues that may arise from using machine-translated content.

Configuring Auto Negotiation

October 5, 2020

Contributed by:

S C

October 5, 2020

Contributed by:

S C

Configuring Auto Negotiation

To enable or disable auto negotiation

In this article