NetScaler Gateway

Configuring the Frequency of Post-Authentication Scans

October 5, 2020

Contributed by:

S C

You can configure NetScaler Gateway to run the post-authentication policy at specified intervals. For example, you configured a client security policy and want it to run on the user device every 10 minutes. You can configure this frequency by creating a custom expression within the policy.

Note: The frequency check functionality for post-authentication policies works only with the NetScaler Gateway Plug-in. If users log on with Citrix Receiver, the endpoint analysis scan runs at logon only.

You can set the frequency (in minutes) when you configure the client security policy by following the procedure Configuring a Post-Authentication Policy. The following figure shows where you can enter a frequency value in the Add Expression dialog box.

Figure 1. Dialog box for configuring the frequency of post-authentication scans

Displays a figure of the dialog box for configuring the frequency of post-authentication scans.

The official version of this content is in English. Some of the Citrix documentation content is machine translated for your convenience only. Citrix has no control over machine-translated content, which may contain errors, inaccuracies or unsuitable language. No warranty of any kind, either expressed or implied, is made as to the accuracy, reliability, suitability, or correctness of any translations made from the English original into any other language, or that your Citrix product or service conforms to any machine translated content, and any warranty provided under the applicable end user license agreement or terms of service, or any other agreement with Citrix, that the product or service conforms with any documentation shall not apply to the extent that such documentation has been machine translated. Citrix will not be held responsible for any damage or issues that may arise from using machine-translated content.

Configuring the Frequency of Post-Authentication Scans

October 5, 2020

Contributed by:

S C

October 5, 2020

Contributed by:

S C

Configuring the Frequency of Post-Authentication Scans

Configuring the Frequency of Post-Authentication Scans

In this article