NetScaler Gateway

Configuring Access Scenario Fallback

October 5, 2020

Contributed by:

S C

SmartAccess allows NetScaler Gateway to determine automatically the methods of access that are allowed for a user device based on the results of an endpoint analysis scan. Access scenario fallback further extends this capability by allowing a user device to fall back from the NetScaler Gateway Plug-in to the Web Interface or StoreFront by using Citrix Receiver if the user device does not pass the initial endpoint analysis scan.

To enable access scenario fallback, you configure a post-authentication policy that determines whether or not users receive an alternative method of access when logging on to NetScaler Gateway. This post-authentication policy is defined as a client security expression that you configure either globally or as part of a session profile. If you configure a session profile, the profile is associated to a session policy that you then bind to users, groups, or virtual servers. When you enable access scenario fallback, NetScaler Gateway initiates an endpoint analysis scan after user authentication. The results for user devices that do not meet the requirements of a fallback post-authentication scan are as follows:

If client choices is enabled, users can log on to the Web Interface or StoreFront by using Receiver only.
If clientless access and client choices are disabled, users can be quarantined into a group that provides access only to the Web Interface or StoreFront.
If clientless access and the Web Interface or StoreFront are enabled on NetScaler Gateway and ICA proxy is disabled, users fall back to clientless access.
If the Web Interface or StoreFront is not configured and clientless access is set to allow, users fall back to clientless access.

When clientless access is disabled, the following combination of settings must be configured for the access scenario fallback:

Define client security parameters for the fallback post-authentication scan.
Define the Web Interface home page.
Disable client choices.
If user devices fail the client security check, users are placed into a quarantine group that allows access only to the Web Interface or StoreFront and to published applications.

The official version of this content is in English. Some of the Citrix documentation content is machine translated for your convenience only. Citrix has no control over machine-translated content, which may contain errors, inaccuracies or unsuitable language. No warranty of any kind, either expressed or implied, is made as to the accuracy, reliability, suitability, or correctness of any translations made from the English original into any other language, or that your Citrix product or service conforms to any machine translated content, and any warranty provided under the applicable end user license agreement or terms of service, or any other agreement with Citrix, that the product or service conforms with any documentation shall not apply to the extent that such documentation has been machine translated. Citrix will not be held responsible for any damage or issues that may arise from using machine-translated content.

Configuring Access Scenario Fallback

October 5, 2020

Contributed by:

S C

October 5, 2020

Contributed by:

S C

Configuring Access Scenario Fallback

Configuring Access Scenario Fallback

In this article