Product Documentation

Citrix ADC MPX 14xxx

The Citrix ADC MPX 14020/14030/14040/14060/14080/14100 are 2U appliances. Each model has two 6-core processors and 64 gigabytes (GB) of memory and sixteen 10G SFP+ ports (16x10G SFP+).

For information on the software releases supported on the Citrix ADC hardware platforms, see Citrix ADC hardware software support matrix.

The following figure shows the front panel of the MPX 14020/14030/14040/14060/14080 (16x10G SFP+) appliance.

Figure 1. Citrix ADC MPX 14020/14030/14040/14060/14080/14100 ( 16x10G SFP+), front panel

localized image

The Citrix ADC MPX 14020/14030/14040/14060/14080/14100 appliances have the following ports:

  • RS232 serial Console Port.
  • 10/100Base-T copper Ethernet Port (RJ45), also called the LOM port. You can use this port to remotely monitor and manage the appliance independently of the Citrix ADC software.
  • Two 10/100/1000Base-T copper Ethernet Management Ports (RJ45), numbered 0/1and 0/2 from left to right. These ports are used to connect directly to the appliancefor system administration functions.
  • Network Ports, sixteen 10G SFP+ ports ( 16x10G SFP+).

Note: The 10G SFP+ ports on these appliances support copper 1G SFP transceivers.

The following figure shows the back panel of the MPX 14020/14030/14040/14060/14080/ 14100  appliance.

Figure 2. Citrix ADC MPX 14020/14030/14040/14060/14080/14100, back panel

localized image

The following components are visible on the back panel of the MPX 14020/14030/14040/14060/14080/14100 appliance:

  • Two 240 GB removable solid-state drives (SSDs).

These appliances are redundant array of independent disks (RAID) devices. In a RAID configuration, the same data is stored on multiple drives to improve performance, increase storage capacity, lower the risk of data loss, and provide fault tolerance.

The two SSDs store the same data. If one fails and you replace it, the new SSD mirrors the other one.

  • Power switch, which turns power to the appliance on or off. Press the switch for lessthan two seconds to turn off the power.
  • Two power supplies, each rated at 1000 watts, 100-240 volts. Each power supply has an LED that indicates the status of the power supply, as described in Common hardware components.
  • Disable alarm button, which is functional only when the appliance has two powersupplies.

Press this button to stop the power alarm from sounding when you have plugged the appliance into only one power outlet, or when one power supply is malfunctioning and you want to continue operating the appliance until it is repaired.

  • Non-maskable interrupt (NMI) Button, used at the request of Technical Support toinitiate a core dump. To press this red button, which is recessed to preventunintentional activation, use a pen, pencil, or other pointed object. The NMI Buttonis also available remotely over the network in the LOM GUI, in the Remote Control menu.

For information about installing the rails, rack mounting the hardware, and connecting the cables, see Installing the Hardware.

For information about performing initial configuration of your appliance, see Initial Configuration.

Citrix ADC MPX 14xxx

In this article