Product Documentation

Citrix ADC MPX 14xxx-40C

The Citrix ADC MPX 14xxx-40C are 2U appliances. Each model has two six-core processors, 64 gigabytes (GB) of memory, four 40G QSFP+ ports, four 10G SFP+ ports, and four 10G Base-T ports.

The following figure shows the front panel of the 14xxx-40C appliance.

Figure 1. Citrix ADC MPX 14020/14020/14060/14080/14100-40C (4x40G QSFP+, 4x10G SFP+, 4x10G Base-T), front panel

localized image

The Citrix ADC MPX14xxx-40C appliances have the following ports:

  • RS232 serial Console Port.
  • 10/100Base-T copper Ethernet Port (RJ45), also called the LOM port. You can use this port to remotely monitor and manage the appliance independently of the Citrix ADC software.
  • Two 10/100/1000Base-T copper Ethernet management ports (RJ45), also called Management ports, numbered 0/1 and 0/2 from left to right. These ports are used to connect directly to the appliance for system administration functions.
  • Network Ports, four 40G QSFP+, four 10G SFP+, and four 10G Base-T ports.

The following figure shows the back panel of the MPX14xxx-40C appliances.

Figure 2. Citrix ADC MPX 14020/14020/14060/14080/14100-40C (4x40G QSFP+, 4x10G SFP+, 4x10G Base-T), back panel

localized image

The following components are visible on the back panel of the MPX14xxx-40C appliances:

  • Two 300 GB removable solid-state drives. These appliances have a redundant array of independent disks (RAID) devices. In a RAID configuration, the same data is stored on multiple drives to improve performance, increase storage capacity, lower the risk of data loss, and provide fault tolerance.
  • Power switch, which turns power to the appliance on or off. Press the switch for less than two seconds to turn off the power. For more information, see Common Hardware Components
  • Two power supplies, each power supply is rated at 1000 watts, 100-240 volts. Each power supply has an LED that indicates the status of the power supply, as described Common hardware components.
  • Disable alarm button. This button is functional when the appliance has two power supplies. Press this button to stop the power alarm from sounding when you have plugged the appliance into only one power outlet, or when one power supply is malfunctioning and you want to continue operating the appliance until it is repaired.
  • Non-maskable interrupt (NMI) Button that is used at the request of Technical Support to initiate a core dump. To press this red button, which is recessed to prevent unintentional activation, use a pen, pencil, or other pointed object. The NMI Button is also available remotely over the network in the LOM GUI, in the Remote Control menu. For more information about lights out management port of the appliance, see Lights out management port of the Citrix ADC MPX appliance.

Citrix ADC MPX 14xxx-40C

In this article