Citrix ADC SDX 14030 FIPS, 14060 FIPS, 14080 FIPS
The Citrix ADC models SDX 14030 FIPS, SDX 14060 FIPS, and SDX 14080 FIPS are 2U appliances. Each model has two quad-core processors, 64 GB memory, 16 10G SFP+ ports (16x10G SFP+).
Figure 1. Citrix ADC SDX 14030/14060/14080 FIPS front panel
The Citrix ADC SDX 14030/14060/14080 FIPS appliances have the following ports:
- RS232 serial Console Port.
- 10/100Base-T copper Ethernet Port (RJ45), also called the LOM port. You can use this port to remotely monitor and manage the appliance independently of the Citrix ADC software.
- Two 10/100/1000Base-T copper Ethernet Management Ports (RJ45), numbered 0/1 and 0/2 from left to right. These ports are used to connect directly to the appliance for system administration functions.
- Sixteen 10G SFP+ ports.
- 10G ports do not support 1G copper or 1G fiber transceivers.
- 40G ports do not support 10G and 1G transceivers.
Figure 2. Citrix ADC SDX 14030/14060/14080 FIPS appliance back panel
The following components are visible on the back panel of the SDX 14030 FIPS, SDX 14060 FIPS, and SDX 14080 FIPS appliances:
- Two 300 GB removable solid-state drives (SSDs). The two leftmost solid-state drives store the Citrix ADC software. The next two solid-state drives store user data. The remaining four solid-state drives are reserved for future use. These appliances are redundant array of independent disks (RAID) devices.
- Power switch. Which turns power to the appliance on or off. Press the switch for less than two seconds to turn off the power.
- Two power supplies, each rated at 1,000 watts, 100–240 volts. Each power supply has an LED that indicates the status of the power supply, see Common Hardware Components.
- Disable alarm button. Which is functional only when the appliance has dual redundant, hot-swappable power supplies. Press this button to silence the power alarm when one of the two power supplies loses input power or when a power supply is malfunctioning.
- Non-maskable interrupt (NMI) button. Used at the request of Technical Support to initiate a core dump. To press this red button, which is recessed to prevent unintentional activation, use a pen, pencil, or other pointed object. The NMI Button is also available remotely over the network in the lights out management GUI, in the Remote Controlment. For more information, see Lights Out Management Port of the Citrix ADC SDX Appliance.
See Configuring an SDX 14000 FIPS Appliance for more information about how to configure an SDX 14030/14060/14080 FIPS appliance.