NetScaler SD-WAN 10.0.6 Release Notes

This release note describes known issues, and fixed issues applicable to the SD-WAN software release 10.0 version 6 for the SD-WAN Standard Edition, WANOP, and Enterprise Edition appliances, and SD-WAN Center.

For information about the previous release versions, see the NetScaler SD-WAN documentation.

Fixed issues

NSSDW-9022: When link state changes, the functionality to check link state does not close the socket descriptor opened to query the link state.

NSSDW-14357: When you perform change management and enable multi stream ICA on newly exported configuration file, GUI error is reported after activation is completed.

NSSDW-14389: The Software Error state is not displayed in the Default_region summary table when software error occurs at the RCN.

NSSDW-14455: A GUI exception occurs when performing Audit Now after creating a non-default RD, and using it to create Route Learning Export Template.

NSSDW-14799: The New Rule added in configuration editor does not show Load Balance when it is added, until audited.

NSSDW-15750: The Change Management Actual Traffic Interruption shows value as error in the MCN Default region details table and in RCN Configuration page.

NSSDW-15911: Allow enabling or disabling of Export route in import filter for an Intranet or Internet service to neighboring sites.

NSSDW-15916: All Virtual paths connecting the MCN to all Branch sites become inactive causing network traffic disruption. The traffic resumes when the SD-WAN appliance is restarted.

SDWANHELP-627 (NSSDW-15735): Unable to store a value > 255 when redistributing from SD-WAN to OSPF.

SDWANHELP-605 (SR# 78534275): In release 10 version 4, the SD-WAN 1000 appliance fails to start during every configuration push.

SDWANHELP-600 (SR# 78396617): After a software upgrade from release 9.3.2 to 9.3.5, the post upgrade SNMP System Name shows as the default Virtual WAN, and does not use the device hostname.

SDWANHELP-649 (SR# 78646995): Excessive Virtual Path packet retransmissions might be experienced with low bandwidth utilization, high loss or congestion, and less than 20 ms RTT times.

Known issues

NSSDW-10133: The port forwarding rules are missing from Dynamic NAT policies when internet access for all the routing domains is enabled.

NSSDW-14605: Routes are marked ineligible even though both gateway and path are active.

NetScaler SD-WAN 10.0.6 Release Notes