- Architecture
- SD-WAN 4100 WANOP
- SD-WAN 5100 WANOP
- Field Replaceable Units
- Supported Features
- Summary of Hardware Specifications
- Lights Out Management Port of the SD-WAN WANOP 4100/5100 Appliance
- Preparing for Installation
- Installing the Hardware
- Planning the Deployment
- Initial Configuration
- Deployment Modes
- Troubleshooting Tips
Deployment Modes
Aug 31, 2017
SD-WAN 4100/5100 appliances have two recommended deployment modes: WCCP and inline. These modes are commonly used without high availability (HA), and less commonly with HA.
At this time, Citrix recommends WCCP mode, with a single router and without HA, for most deployments. Use inline mode when WCCP is not available.
Although not all of the following modes are recommended at this time, they are all supported:
- WCCP mode with a single router
- WCCP mode with a single router and high availability
- Cascade of two or more appliances in WCCP mode along with a NetScaler MPX Appliance
- Cascade of two or more appliances in WCCP mode along with a NetScaler MPX Appliance in HA
- Inline mode
- Inline mode in HA
- Virtual inline mode
- Virtual inline mode in HA
Note
While modes other than WCCP and inline are supported, they are incompletely documented and are not recommended for typical installations. Please contact your Citrix representative when considering one of these modes.