This mode allows
multiple routers to share an appliance. The appliance forwards virtual inline
output packets back to where they came from, as indicated by the Ethernet
address of the incoming packet. If two routers share a single appliance, each
gets its own traffic back, but not the traffic from the other router. This mode
also works with a single router.
- To enable the Return to Ethernet Sender mode by using the
configuration utility
-
- Navigate to the
page.
- Click the Configure
Layer 2 Parameter link, as shown in the following figure.
- In the Configure
Layer 2 Parameter dialog box, select the
Return to Ethernet Sender option, as
shown in the following figure.
- Click
OK.
- To enable the Return to Ethernet Sender mode by using the command
line interface, run the following command
- > set L2Param -returnToEthernetSender ENABLED