Enabling AAA

To use the AAA - Application Traffic feature, you must enable it. You can configure AAA entities—such as the authentication and traffic management virtual servers—before you enable the AAA feature, but the entities will not function until the feature is enabled.

To enable AAA by using the command line interface

At the command prompt, type the following commands to enable AAA and verify the configuration:

  • enable ns feature AAA

  • show ns feature


  • enable feature AAA<!--NeedCopy-->


  • show ns feature<!--NeedCopy-->

     Feature                  Acronym              Status
     -------                  -------              ------
     1)  Web Logging            WL                   OFF
     2)  Surge Protection       SP                   ON
     15)  AAA                  AAA                   ON
     23)    HTML Injection     HTMLInjection         ON
     24)    NetScaler Push      push                 OFF  Done

To enable AAA by using the configuration utility

  1. Navigate to System > Settings.
  2. In the details pane, under Modes and Features, click Change basic features.
  3. In the Configure Basic Features dialog box, select the Authentication, Authorization and Auditing check box.
  4. Click OK.
Enabling AAA