NetScaler

Synchronizing cluster configurations

September 21, 2020

Contributed by:

NetScaler appliance configurations that are available on the configuration coordinator are synchronized to the other nodes of the cluster when:

A node joins the cluster
A node rejoins the cluster
A new command is executed through the cluster IP address.

Additionally, you can forcefully synchronize the configurations that are available on the configuration coordinator (full synchronization) to a specific cluster node. Make sure you synchronize one cluster node at a time, otherwise the cluster can get affected.

To synchronize cluster configurations by using the command line interface

At the command prompt of the appliance on which you want to synchronize the configurations, type:

force cluster sync

To synchronize cluster configurations by using the configuration utility

Log on to the appliance on which you want to synchronize the configurations.
Navigate to System > Cluster.
In the details pane, under Utilities, click Force cluster sync.
Click OK.

The official version of this content is in English. Some of the Citrix documentation content is machine translated for your convenience only. Citrix has no control over machine-translated content, which may contain errors, inaccuracies or unsuitable language. No warranty of any kind, either expressed or implied, is made as to the accuracy, reliability, suitability, or correctness of any translations made from the English original into any other language, or that your Citrix product or service conforms to any machine translated content, and any warranty provided under the applicable end user license agreement or terms of service, or any other agreement with Citrix, that the product or service conforms with any documentation shall not apply to the extent that such documentation has been machine translated. Citrix will not be held responsible for any damage or issues that may arise from using machine-translated content.

Synchronizing cluster configurations

September 21, 2020

Contributed by:

September 21, 2020

Contributed by:

Synchronizing cluster configurations

To synchronize cluster configurations by using the command line interface

To synchronize cluster configurations by using the configuration utility

In this article