NetScaler

Configuring policy based logging for content switching

September 21, 2020

Contributed by:

C S

You can configure policy based logging for a content switching policy. Policy based logging enables you to specify a format for log messages. The contents of the log message are defined by using a default syntax expression in the content switching policy. When the content switching action specified in the policy is performed, the NetScaler appliance constructs the log message from the expression and writes the message to the log file. Policy based logging is particularly useful if you want to test and troubleshoot a configuration in which content switching actions identify the target load balancing virtual server at run time.

Note

If multiple policies bound to a given virtual server evaluate to TRUE and are configured with an audit message action, the NetScaler appliance does not perform all the audit message actions. It performs only the audit message action that is configured for the policy whose content switching action is performed.

To configure policy based logging for a content switching policy, you must first configure an audit message action. For more information about configuring an audit message action, see Configuring the NetScaler appliance for Audit Logging. After you configure the audit message action, you specify the action in a content switching policy.

To configure policy based logging for a content switching policy by using the command line interface

At the command line, type the following commands to configure policy based logging for a content switching policy and verify the configuration:

set cs policy <policyName> -logAction <string>
show cs policy <policyName>

Example

> set cs policy cspol1 -logAction csLogAction
 Done
> show cs policy cspol1

    Policy: cspol1  Rule: TRUE  Action: csact1
    LogAction: csLogAction
    Hits: 0

1)  CS Vserver: csvs1
    Priority: 10
 Done
>
<!--NeedCopy-->

To configure policy based logging for a content switching policy by using the configuration utility

Navigate to Traffic Management > Content Switching > Policies, open a policy and, in the Log Action list, select a log action for the policy.

The official version of this content is in English. Some of the Citrix documentation content is machine translated for your convenience only. Citrix has no control over machine-translated content, which may contain errors, inaccuracies or unsuitable language. No warranty of any kind, either expressed or implied, is made as to the accuracy, reliability, suitability, or correctness of any translations made from the English original into any other language, or that your Citrix product or service conforms to any machine translated content, and any warranty provided under the applicable end user license agreement or terms of service, or any other agreement with Citrix, that the product or service conforms with any documentation shall not apply to the extent that such documentation has been machine translated. Citrix will not be held responsible for any damage or issues that may arise from using machine-translated content.

Configuring policy based logging for content switching

September 21, 2020

Contributed by:

C S

September 21, 2020

Contributed by:

C S

Configuring policy based logging for content switching

To configure policy based logging for a content switching policy by using the command line interface

Example

To configure policy based logging for a content switching policy by using the configuration utility

In this article