Product Documentation

Configuring VLANs on a Single Subnet

Aug 29, 2013

Before configuring a VLAN on a single subnet, make sure that Layer 2 Mode is enabled.

The following figure shows a single subnet environment

Figure 1. VLAN on a Single Subnet

In the above figure:
  1. The default router for the NetScaler and the servers is Router 1.
  2. Layer 2 mode must be enabled on the NetScaler for the NetScaler to have direct access to the servers.


  3. For this subnet, a virtual server can be configured for load balancing on the NetScaler appliance.

To configure a VLAN on a single subnet, follow the procedures described in Creating or Modifying a VLAN. VLAN configuration parameters are not required, because the network interfaces are members of this VLAN.