Product Documentation

Setting the Timeout for Dynamic ARP Entries

Aug 28, 2013

You can globally set an aging time (time-out value) for dynamically learned ARP entries. The new value applies only to ARP entries that are dynamically learned after the new value is set. Previously existing ARP entries expire after the previously configured aging time.

You can specify an ARP time-out value of from 1 through 1200 seconds.

To set the time-out for dynamic ARP entries by using the command line interface

At the command prompt, type the following commands to set the time-out for dynamic ARP entries and verify its configuration:

  • set arpparam -timeout <positive_integer>]
  • show arpparam

Example

``` pre codeblock

set arpparam -timeout 500 Done ```

To set the time-out for dynamic ARP entries to its default value by using the command line interface

At the command prompt, type the following commands to set the time-out for dynamic ARP entries to its default value and verify its configuration:

  • unset arpparam
  • show arpparam

Example

``` pre codeblock

unset arpparam Done ```

To set the time-out for dynamic ARP entries by using the configuration utility

Navigate to System > Network, in the Settings group, click Configure ARP Global Parameters, and set the ARP Table Entry Timeout parameter.