Removing a cluster node

When a node is removed from the cluster, the cluster configurations are cleared from the node (by internally executing the clear ns config -extended command). The SNIP addresses, MTU settings of the backplane interface, and all VLAN configurations (except the default VLAN and NSVLAN) are also cleared from the appliance.

Note

  • If the deleted node was the cluster configuration coordinator, another node is automatically selected as the cluster configuration coordinator, and the cluster IP address is assigned to that node. All the current cluster IP address sessions will be invalid and you will have to start a new session.
  • To delete the whole cluster, you must remove each node individually. When you remove the last node, the cluster IP address(es) are deleted.
  • When an active node is removed, the traffic serving capability of the cluster is reduced by one node. Existing connections on this node are terminated.

To remove a cluster node by using the command line interface

For NetScaler 10.1 and later versions

Logon to the cluster IP address and at the command prompt, type:

rm cluster node <nodeId>

Note

If the cluster IP address is unreachable from the node, execute the rm cluster instance command on the NSIP address of that node itself.

For NetScaler 10

  1. Log on to the node that you want to remove from the cluster and remove the reference to the cluster instance.

    rm cluster instance <clId>
    
    save ns config
    
  2. Log on to the cluster IP address and remove the node from which you removed the cluster instance.

    rm cluster node <nodeId>
    
    save ns config
    

    Make sure you do not run the rm cluster node command from the local node as this results in inconsistent configurations between the configuration coordinator and the node.

To remove a cluster node by using the configuration utility

On the cluster IP address, navigate to System > Cluster > Nodes, select the node you want to remove and click Remove.