NetScaler SDX

Configuring Syslog Notifications

April 13, 2023

Contributed by:

S S S

SYSLOG is a standard logging protocol. It has two components: the SYSLOG auditing module, which runs on the NetScaler SDX appliance, and the SYSLOG server, which can run on a remote system. SYSLOG uses user data protocol (UDP) for data transfer.

When you run a SYSLOG server, it connects to the SDX appliance. The appliance then starts sending all the log information to the SYSLOG server, and the server can filter the log entries before storing them in a log file. A SYSLOG server can receive log information from more than one SDX appliance, and an SDX appliance can send log information to more than one SYSLOG server.

The log information that a SYSLOG server collects from an SDX appliance is stored in a log file in the form of messages. These messages typically contain the following information:

The IP address of the SDX appliance that generated the log message
A time stamp
The message type
The log level (Critical, Error, Notice, Warning, Informational, Debug, Alert, or Emergency)
The message information

You can use this information to analyze the source of the alert and take corrective action if required. First configure a syslog server that the appliance sends log information to, and then specify the data and time format for recording the log messages.

To configure a Syslog Server

Navigate to System > Notifications > Syslog Servers.
In the details pane, click Add.
In the Create Syslog Serverpage, specify values for the syslog server parameters. For a description of a parameter, hover the mouse over the corresponding field.
Click Add, and then click Close.

To configure the syslog parameters

Navigate to System > Notifications > Syslog Servers.
In the details pane, click Syslog Parameters.
In the Configure Syslog Parameterspage, specify the date and time format.
Click OK, and then click Close.

The official version of this content is in English. Some of the Cloud Software Group documentation content is machine translated for your convenience only. Cloud Software Group has no control over machine-translated content, which may contain errors, inaccuracies or unsuitable language. No warranty of any kind, either expressed or implied, is made as to the accuracy, reliability, suitability, or correctness of any translations made from the English original into any other language, or that your Cloud Software Group product or service conforms to any machine translated content, and any warranty provided under the applicable end user license agreement or terms of service, or any other agreement with Cloud Software Group, that the product or service conforms with any documentation shall not apply to the extent that such documentation has been machine translated. Cloud Software Group will not be held responsible for any damage or issues that may arise from using machine-translated content.

Configuring Syslog Notifications

April 13, 2023

Contributed by:

S S S

April 13, 2023

Contributed by:

S S S

Configuring Syslog Notifications

To configure a Syslog Server

To configure the syslog parameters

In this article