XenCenter

Change Virtual Network Interface Properties

March 14, 2024

Contributed by:

Note:

XenCenter YYYY.x.x is not yet supported for use with Citrix Hypervisor 8.2 CU1 in production environments. To manage your Citrix Hypervisor 8.2 CU1 production environment, use XenCenter 8.2.7. For more information, see the XenCenter 8.2.7 documentation.

You can install XenCenter 8.2.7 and XenCenter YYYY.x.x on the same system. Installing XenCenter YYYY.x.x does not overwrite your XenCenter 8.2.7 installation.

To change properties of a virtual network interface, open the Virtual Interface Properties dialog box by doing one of the following:

Click the VM’s Networking tab, then select the virtual network interface and click Properties.
On the Network page of the New VM wizard, click Edit.

You can change the network location and MAC address of a virtual network interface, and you might also be able to set its I/O priority.

Property	Description
Network	The network location of the virtual network interface.
MAC address	The MAC address of the virtual network interface. You can autogenerate this value or enter it manually in the form XY:XX:XX:XX:XX:XX where X is any hexadecimal digit, and Y is 2, 6, A or E.
Enable QoS limit	Select this option and enter a value in kilobytes per second (kB/s) to set an optional I/O priority Quality of Service (QoS) setting for maximum network transfer rate. When memory resources are low, using I/O throttling in this way slows the memory processing and helps make the system more stable by preventing crashes.

The official version of this content is in English. Some of the Cloud Software Group documentation content is machine translated for your convenience only. Cloud Software Group has no control over machine-translated content, which may contain errors, inaccuracies or unsuitable language. No warranty of any kind, either expressed or implied, is made as to the accuracy, reliability, suitability, or correctness of any translations made from the English original into any other language, or that your Cloud Software Group product or service conforms to any machine translated content, and any warranty provided under the applicable end user license agreement or terms of service, or any other agreement with Cloud Software Group, that the product or service conforms with any documentation shall not apply to the extent that such documentation has been machine translated. Cloud Software Group will not be held responsible for any damage or issues that may arise from using machine-translated content.

Was this helpful

Change Virtual Network Interface Properties

March 14, 2024

Contributed by:

March 14, 2024

Contributed by:

Change Virtual Network Interface Properties

In this article