- Paramètres de stratégie des images en mouvement
- Paramètres de stratégie Images immobiles
The Moving Images section contains settings that enable you to remove or alter compression for dynamic images.
This setting specifies the minimum acceptable image quality for Adaptive Display. The less compression used, the higher the quality of images displayed. Choose from Ultra High, Very High, High, Normal, or Low compression.
By default, this is set to Normal.
By default, Adaptive Display is enabled.
For VDA versions 7.0 through 7.6, this setting applies only when Legacy graphics mode is enabled. For VDA versions 7.6 FP1, FP2, FP3, and LTSR, this setting applies when Legacy graphics mode is enabled, or when the legacy graphics mode is disabled and a video codec is not used to compress graphics.
When legacy graphics mode is enabled, the session must be restarted before policy changes take effect. Adaptive Display is mutually exclusive with Progressive Display; enabling Adaptive Display disables Progressive Display and vice versa. However, both Progressive Display and Adaptive Display can be disabled at the same time. Progressive Display, as a legacy feature, is not recommended for XenApp or XenDesktop. Setting Progressive threshold Level will disable Adaptive Display.
This setting provides a less detailed but faster initial display of images.
By default, no progressive compression is applied.
The more detailed image, defined by the normal lossy compression setting, appears when it becomes available. Use Very High or Ultra High compression for improved viewing of bandwidth-intensive graphics such as photographs.
This setting represents the maximum bandwidth in kilobits per second for a connection to which progressive compression is applied. This is applied only to client connections under this bandwidth.
By default, the threshold value is 2147483647 kilobits per second.
By default, this is set to 10fps.
For VDA versions 7.0 through 7.6, this setting applies only when Legacy graphics mode is enabled. For VDA versions 7.6 FP1, FP2, FP3, and LTSR, this setting applies when the Legacy graphics mode is disabled or enabled.