configuration of a CloudBridge appliance, perform the following tasks::
- Configure the appliance for
use on your site.
- Install the Citrix
- Enable acceleration.
- Enable traffic shaping
(inline mode only).
deployments, this configuration might be all you need, because most
acceleration features are enabled by default and require no additional
You can configure
the appliance connecting the appliance to your computer through either the
Ethernet port or the serial console. The following procedure enables you to
configure the appliance by connecting it to your computer through the Ethernet
If you want to
configure the appliance by connecting it to the computer through the serial
console, assign the management service IP address from your
Assigning a Management IP
Address through the Serial Console procedure, and then run steps 4
through 25 of the following procedure.
Note: Make sure that
you have physical access to the appliance.