You can use the
Setup Wizard to complete all the first time configurations in a single flow.
You can use the
wizard to configure network configuration details and system settings, change
the default administrative password, and manage and update licenses.
You can also use
this wizard to modify the network configuration details that you specified for
the NetScaler SDX appliance during initial configuration.
To access the
wizard, navigate to Configuration > System and, under Set Up Appliance,
click Setup Wizard.
On the Platform
Configuration page, you can configure network configuration details, system
settings, and change the default administrative password.
- Interface*—The interface
through which clients connect to the Management Service. Possible values: 0/1,
0/2. Default: 0/1.
- XenServer IP Address*—IP
address of the XenServer server.
- Management Service IP
Address*—IP address of the Management Service.
- Netmask*—Mask for the
subnet in which the SDX appliance is located.
- Gateway*—Default gateway
for the network.
- DNS Server—IP address of
the DNS server.
Settings, you can specify that the Management Service and a NetScaler instance
should communicate with each other only over a secure channel. You can also
restrict access to the Management Service user interface. Clients can log on
the Management Service user interface only by using https.
You can modify the
time zone of the Management Service and the XenServer server. The default time
zone is UTC. You can change the Administrative password by selecting the Change
Password check box and typing the new password.
Licenses you can manage and allocate licenses. You can use your hardware serial
number (HSN) or your license activation code (LAC) to allocate your licenses.
Alternatively, if a license is already present on your local computer, you can
upload it to the appliance.
licenses on the appliance and click Done to complete the initial configuration.