Product Documentation

inatparam

Sep 12, 2016

The following operations can be performed on "inatparam":

set inatparam

Set the inat parameter

Synopsys

set inatparam [-nat46v6Prefix <ipv6_addr|*> [-td <positive_integer>]] [-nat46IgnoreTOS ( YES | NO )] [-nat46ZeroCheckSum ( ENABLED | DISABLED )] [-nat46v6Mtu <positive_integer>] [-nat46FragHeader ( ENABLED | DISABLED )]

Arguments

nat46v6Prefix

The prefix used for translating packets received from private IPv6 servers into IPv4 packets. This prefix has a length of 96 bits (128-32 = 96). The IPv6 servers embed the destination IP address of the IPv4 servers or hosts in the last 32 bits of the destination IP address field of the IPv6 packets. The first 96 bits of the destination IP address field are set as the IPv6 NAT prefix. IPv6 packets addressed to this prefix have to be routed to the NetScaler appliance to ensure that the IPv6-IPv4 translation is done by the appliance.

td

Integer value that uniquely identifies the traffic domain in which you want to configure the entity. If you do not specify an ID, the entity becomes part of the default traffic domain, which has an ID of 0.

Default value: 0

Minimum value: 0

Maximum value: 4094

nat46IgnoreTOS

Ignore TOS.

Possible values: YES, NO

Default value: NO

nat46ZeroCheckSum

Calculate checksum for UDP packets with zero checksum

Possible values: ENABLED, DISABLED

Default value: ENABLED

nat46v6Mtu

MTU setting for the IPv6 side. If the incoming IPv4 packet greater than this, either fragment or send icmp need fragmentation error.

Default value: 1280

Minimum value: 1280

Maximum value: 9216

nat46FragHeader

When disabled, translator will not insert IPv6 fragmentation header for non fragmented IPv4 packets

Possible values: ENABLED, DISABLED

Default value: ENABLED

Example

set inat parameter -nat46ignoretos YES

unset inatparam

Unset the inat parameter.Refer to the set inatparam command for meanings of the arguments.

Synopsys

unset inatparam [-nat46v6Prefix [-td <positive_integer>]]

Example

unset inatparam -nat46v6Prefix -td 1

show inatparam

Show the inat parameters.

Synopsys

show inatparam [-td <positive_integer>]

Arguments

td

Integer value that uniquely identifies the traffic domain in which you want to configure the entity. If you do not specify an ID, the entity becomes part of the default traffic domain, which has an ID of 0.

Default value: 0

Minimum value: 0

Maximum value: 4094

Outputs

nat46v6Prefix

The prefix used for translating packets received from private IPv6 servers into IPv4 packets. This prefix has a length of 96 bits (128-32 = 96). The IPv6 servers embed the destination IP address of the IPv4 servers or hosts in the last 32 bits of the destination IP address field of the IPv6 packets. The first 96 bits of the destination IP address field are set as the IPv6 NAT prefix. IPv6 packets addressed to this prefix have to be routed to the NetScaler appliance to ensure that the IPv6-IPv4 translation is done by the appliance.

nat46IgnoreTOS

Ignore TOS.

nat46ZeroCheckSum

Calculate checksum for UDP packets with zero checksum

nat46v6Mtu

MTU setting for the IPv6 side. If the incoming IPv4 packet greater than this, either fragment or send icmp need fragmentation error.

nat46FragHeader

When disabled, translator will not insert IPv6 fragmentation header for non fragmented IPv4 packets

setcmdflag

devno

count

stateflag

Example

show inat params