Product Documentation

L4Param

Sep 12, 2016

The following operations can be performed on "L4Param":

set L4Param

Set Layer 4 related global settings on the NetScaler

Synopsys

set L4Param [-l2ConnMethod <l2ConnMethod>] [-l4switch ( ENABLED | DISABLED )]

Arguments

l2ConnMethod

Layer 2 connection method based on the combination of channel number, MAC address and VLAN. It is tuned with l2conn param of lb vserver. If l2conn of lb vserver is ON then method specified here will be used to identify a connection in addition to the 4-tuple (<source IP>:<source port>::<destination IP>:<destination port>).

Possible values: Channel, Vlan, VlanChannel, Mac, MacChannel, MacVlan, MacVlanChannel

Default value: MacVlanChannel

l4switch

In L4 switch topology, always clients and servers are on the same side. Enable l4switch to allow such connections.

Possible values: ENABLED, DISABLED

Default value: DISABLED

Example

set l4param

unset L4Param

Use this command to remove L4Param settings.Refer to the set L4Param command for meanings of the arguments.

Synopsys

unset L4Param [-l2ConnMethod] [-l4switch]

show L4Param

Displays the settings of global Layer 4 parameters.

Synopsys

show L4Param

Outputs

l2ConnMethod

Layer 2 connection method based on the combination of channel number, MAC address and VLAN. It is tuned with l2conn param of lb vserver. If l2conn of lb vserver is ON then method specified here will be used to identify a connection in addition to the 4-tuple (<source IP>:<source port>::<destination IP>:<destination port>).

l4switch

In L4 switch topology, always clients and servers are on the same side. Enable l4switch to allow such connections.