Product Documentation

ptp

Sep 12, 2016

The following operations can be performed on "ptp":

set ptp

Specifies whether to use Precision Time Protocol (PTP) to synchronize time across cluster nodes. This command is applicable in a cluster setup only. If you do not want to use PTP, you must disable PTP, by using this command, and instead enable NTP.

Synopsys

set ptp -state ( DISABLE | ENABLE )

Arguments

state

Enables or disables Precision Time Protocol (PTP) on the appliance. If you disable PTP, make sure you enable Network Time Protocol (NTP) on the cluster.

Possible values: DISABLE, ENABLE

Default value: ENABLE

show ptp

Displays the status of Precision Time Protocol (PTP) on the appliance.

Synopsys

show ptp

Outputs

state

Enables or disables Precision Time Protocol (PTP) on the appliance. If you disable PTP, make sure you enable Network Time Protocol (NTP) on the cluster.