A solid-state drive (SSD)
is a high-performance device that stores data in solid-state flash memory.
4000/5000 software is
stored on the solid-state drive (SSD).
To replace a solid-state
Locate the SSD on the
back panel of the appliance. Push the safety latch of the drive cover to the
right or down, depending on the platform, while pulling out on the drive handle
to disengage. Pull out the faulty drive.
Figure 1. Removing the Existing Solid-State Drive
Verify that the
replacement SSD is the correct type for the platform.
Pick up the new SSD, open
the drive handle fully to the left or up, and insert the drive into the slot as
far as possible. To seat the drive, close the handle flush with the rear of the
appliance so that the drive locks securely into the slot.
Important: When you insert the drive, make sure that the Citrix product
label is at the top if the drive is inserted horizontally or at the right if
the drive is inserted vertically.
Figure 2. Inserting the Replacement Solid-State Drive
Turn on the appliance.
Log on to the default IP address by using a web browser, or
connect to the serial console by using a console cable, to perform the initial