Product Documentation

Enabling the Responder Feature

Oct 29, 2013
To use the Responder feature, you must first enable it.

To enable the responder feature by using the command line interface

At the command prompt, type the following commands to enable the responder feature and verify the configuration:
  • enable ns feature<feature>
  • show ns feature

Example

enable ns feature Responder 
 Done 
> show ns feature 
 
        Feature                        Acronym              Status 
        -------                        -------              ------ 
 1)     Web Logging                    WL                   ON 
 2)     Surge Protection               SP                   ON 
 . 
 . 
 . 
 22)    Responder                      RESPONDER            ON 
 23)    HTML Injection                 HTMLInjection        ON 
 24)    NetScaler Push                 push                 OFF 
 Done 
>

To enable the responder feature by using the configuration utility

  1. In the navigation pane, expand System, and then click Settings.
  2. In the details pane, under Modes and Features, click Change advanced features.
  3. In the Configure Advanced Features dialog box, select the Responder check box, and then click OK.
  4. In the Enable/Disable Feature(s)? dialog box, click YES. A message appears in the status bar, stating that the feature has been enabled.