Product Documentation

Enabling Content Switching

Oct 31, 2013

To use the content switching feature, you must enable content switching. You can configure content switching entities even though the content switching feature is disabled. However, the entities will not work.

To enable content switching by using the command line interface

At the command prompt, type the following commands to enable content switching and verify the configuration:

  • enable ns feature CS
  • show ns feature

Example

 
> enable  feature ContentSwitch 
 Done 
> show feature 
 
        Feature                        Acronym              Status 
        -------                        -------              ------ 
 1)     Web Logging                    WL                   OFF 
 2)     Surge Protection               SP                   ON 
 3)     Load Balancing                 LB                   ON 
 4)     Content Switching              CS                   ON 
 . 
 . 
 . 
 22)    Responder                      RESPONDER            ON 
 23)    HTML Injection                 HTMLInjection        ON 
 24)    NetScaler Push                 push                 OFF 
 Done 

To enable content switching by using the configuration utility

Navigate to System > Settings and, in the Modes and Features group, select Configure Basic Features, and select Content Switching.