Arctera

Support for configuring latency threshold for metro and geo arrays

December 9, 2025

Contributed by:

InfoScale now lets you configure the latency threshold value using a tunable parameter for the metro and geo arrays. You can assign a new latency threshold difference value to a specified enclosure. Use the latency_threshold_difference tunable parameter to change the corresponding value. Note that the tunable is only applicable to the metro arrays.

For details, refer to the Dynamic Multi-Pathing Administrator’s Guide.

The official version of this content is in English. Some of the Cloud Software Group documentation content is machine translated for your convenience only. Cloud Software Group has no control over machine-translated content, which may contain errors, inaccuracies or unsuitable language. No warranty of any kind, either expressed or implied, is made as to the accuracy, reliability, suitability, or correctness of any translations made from the English original into any other language, or that your Cloud Software Group product or service conforms to any machine translated content, and any warranty provided under the applicable end user license agreement or terms of service, or any other agreement with Cloud Software Group, that the product or service conforms with any documentation shall not apply to the extent that such documentation has been machine translated. Cloud Software Group will not be held responsible for any damage or issues that may arise from using machine-translated content.

Was this helpful

Support for configuring latency threshold for metro and geo arrays

December 9, 2025

Contributed by:

December 9, 2025

Contributed by:

Support for configuring latency threshold for metro and geo arrays

In this article