This content has been machine translated dynamically.
Dieser Inhalt ist eine maschinelle Übersetzung, die dynamisch erstellt wurde. (Haftungsausschluss)
Cet article a été traduit automatiquement de manière dynamique. (Clause de non responsabilité)
Este artículo lo ha traducido una máquina de forma dinámica. (Aviso legal)
此内容已经过机器动态翻译。 放弃
このコンテンツは動的に機械翻訳されています。免責事項
이 콘텐츠는 동적으로 기계 번역되었습니다. 책임 부인
Este texto foi traduzido automaticamente. (Aviso legal)
Questo contenuto è stato tradotto dinamicamente con traduzione automatica.(Esclusione di responsabilità))
This article has been machine translated.
Dieser Artikel wurde maschinell übersetzt. (Haftungsausschluss)
Ce article a été traduit automatiquement. (Clause de non responsabilité)
Este artículo ha sido traducido automáticamente. (Aviso legal)
この記事は機械翻訳されています.免責事項
이 기사는 기계 번역되었습니다.책임 부인
Este artigo foi traduzido automaticamente.(Aviso legal)
这篇文章已经过机器翻译.放弃
Questo articolo è stato tradotto automaticamente.(Esclusione di responsabilità))
Translation failed!
Configure Inline Mode
Note: These instructions are valid only for appliances that were provisioned from a factory-reset state with the release 7.1 Configuration Wizard. For appliances that have been updated to release 7.1, but not reprovisioned from a factory-reset state, see the release 7.0 documentation.
Basic configuration is performed in release 7.1 Configuration Wizard. More configuration is required only if you use VLAN trunking on data passing through the bridges.
To configure inline mode
- Do not attach the bridges to your traffic networks yet. Begin by provisioning the appliance with the configuration wizard.
- If your traffic does not contain tagged VLAN traffic, skip to the last step of this procedure.
- Navigate to the NetScaler instance at Configuration > NetScaler > Instances and click on the IP address of the NetScaler instance.
- If the Citrix SD-WAN Connector Get Started page appears, ignore it.
- Click Configuration > Network > VLANs > Add.
- In the Create VLANdialog box, configure the tagged VLANs to use bridge #1. In the VLAN Id field, enter the VLAN ID of the first tagged VLAN (VLAN1.1 on your worksheet). Under Interfaces, clear all the check boxes. Then, select Active and Tagged for the first port of the bridge (T9 on your worksheet) and the second port of the bridge (T10). Click Create.
- Repeat the previous step for any remaining VLANs using bridge #1 (VLAN1.2, VLAN1.3, and so on).
- Repeat for any additional bridge pairs.
- Click Close.
- Click Save to save your configuration.
- Connect the bridges to your traffic networks. Configuration is complete.
Share
Share
In this article
This Preview product documentation is Cloud Software Group Confidential.
You agree to hold this documentation confidential pursuant to the terms of your Cloud Software Group Beta/Tech Preview Agreement.
The development, release and timing of any features or functionality described in the Preview documentation remains at our sole discretion and are subject to change without notice or consultation.
The documentation is for informational purposes only and is not a commitment, promise or legal obligation to deliver any material, code or functionality and should not be relied upon in making Cloud Software Group product purchase decisions.
If you do not agree, select I DO NOT AGREE to exit.