NetScaler Gateway

About NetScaler Gateway

October 5, 2020

Contributed by:

S C

NetScaler Gateway is easy to deploy and simple to administer. The most typical deployment configuration is to locate the NetScaler Gateway appliance in the DMZ. You can install multiple NetScaler Gateway appliances in the network for more complex deployments.

The first time you start NetScaler Gateway, you can perform the initial configuration by using a serial console, the Setup Wizard in the configuration utility, or Dynamic Host Configuration Protocol (DHCP). On the MPX appliance, you can use the LCD keypad on the front panel of the appliance to perform the initial configuration. You can configure basic settings that are specific to your internal network, such as the IP address, subnet mask, default gateway IP address, and Domain Name System (DNS) address. After you configure the basic network settings, you then configure the settings specific to the NetScaler Gateway operation, such as the options for authentication, authorization, network resources, virtual servers, session policies, and endpoint policies.

Before you install and configure NetScaler Gateway, review the topics in this section for information about planning your deployment. Deployment planning can include determining where to install the appliance, understanding how to install multiple appliances in the DMZ, as well as licensing requirements. You can install NetScaler Gateway in any network infrastructure without requiring changes to the existing hardware or software running in the secure network. NetScaler Gateway works with other networking products, such as server load balancers, cache engines, firewalls, routers, and IEEE 802.11 wireless devices.

You can write your settings in the Pre-Installation Checklist to have on hand before you configure NetScaler Gateway.


NetScaler Gateway Appliances	Provides information about NetScaler Gateway appliances and the appliance installation instructions.
Pre-Installation Checklist	Provides planning information to review and a list of tasks to complete before you install NetScaler Gateway in your network.
Common Deployments	Provides information about deploying the NetScaler Gateway in the network DMZ, in a secure network without a DMZ, and with additional appliances to support load balancing and failover. Also provides information about deploying NetScaler Gateway with Citrix XenApp and Citrix XenDesktop.

Licensing

Provides information about installing licenses on the appliance. Also provides information about installing licenses on multiple NetScaler Gateway appliances.

The official version of this content is in English. Some of the Citrix documentation content is machine translated for your convenience only. Citrix has no control over machine-translated content, which may contain errors, inaccuracies or unsuitable language. No warranty of any kind, either expressed or implied, is made as to the accuracy, reliability, suitability, or correctness of any translations made from the English original into any other language, or that your Citrix product or service conforms to any machine translated content, and any warranty provided under the applicable end user license agreement or terms of service, or any other agreement with Citrix, that the product or service conforms with any documentation shall not apply to the extent that such documentation has been machine translated. Citrix will not be held responsible for any damage or issues that may arise from using machine-translated content.

About NetScaler Gateway

October 5, 2020

Contributed by:

S C

October 5, 2020

Contributed by:

S C

About NetScaler Gateway

In this article