XenCenter

Troubleshoot XenServer Conversion Manager

This section provides information about troubleshooting the conversion process and converted VMs.

Problems starting a converted VM

In general, conversion runs smoothly and XenServer Conversion Manager virtual appliance converts VMs without any issues. However, in some rare cases, you might receive errors when attempting to open converted VMs. The following sections provide some guidance on resolving errors and other issues.

Blue screen with Windows STOP code 0x0000007B

This stop code indicates that XenServer Conversion Manager virtual appliance was unable to configure a Windows device that is critical to boot in XenServer for the first time. Save the logs and send them to Support for further guidance.

Windows product activation

Depending on your licensing model, an error message on system activation might appear when you attempt to start a Windows VM.

Lost network settings in a Windows VM

If you import a Windows VM from an ESXi server to XenServer, the IPv4/IPv6 network settings can be lost. To retain the network settings, reconfigure the IPv4/IPv6 settings after completing the conversion.

Unable to start VMware SCSI disk

If a VMware VM boots from a SCSI disk but also has IDE hard disks configured, the VM might not boot when you convert it to XenServer. This issue occurs because the migration process assigns the IDE hard disks lower device numbers than SCSI disks. However, XenServer boots from the hard disk assigned to device 0. To resolve this issue, rearrange the virtual disk position in XenCenter so that the VM reboots from the virtual disk that contains the operating system.

To change the position of the virtual disk containing the operating system:

  1. In the XenCenter Resources pane, select the powered off guest VM.

  2. Select the Storage tab.

  3. From the Virtual Disks list, select the virtual disk containing the operating system and then click Properties.

  4. In the virtual disk’s Properties dialog, click the vm_name tab to display device options.

  5. From the Device Position list, select 0 and Click OK.

Problems during conversion

If you experience problems or errors when converting VMs, try exporting the VMware VM as an OVF package. If you cannot export the VMware VM as an OVF package, Conversion Manager cannot convert this VM. Use the error messages you receive when attempting to export the VM as an OVF package to troubleshoot and fix the issues with your VMware VM. For example, you might have to configure a network or a storage controller before the VM can be exported as an OVF package or converted. For more information about troubleshooting your VMware ESXi/vCenter VMs, see the VMware documentation.

If you see any errors when converting Linux VMs, remove the converted VM, restart the XenServer Conversion Manager virtual appliance and retry.

Logs of failed conversions are stored in the XenServer Conversion Manager virtual appliance and can be retrieved by clicking Fetch All Logs on the Conversion Manager window. When you contact Support to raise any issues, we recommend that you provide the conversion log file and, additionally, a full server status report for troubleshooting. For more information, see Creating a Server Status Report.

Troubleshoot XenServer Conversion Manager