XenCenter

Disable high availability

Note:

XenCenter YYYY.x.x is currently in preview and is not supported for production use. Note that any future references to production support apply only when XenCenter YYYY.x.x and XenServer 8 go from preview status to general availability.

You can use XenCenter YYYY.x.x to manage your XenServer 8 and Citrix Hypervisor 8.2 CU1 non-production environments. However, to manage your Citrix Hypervisor 8.2 CU1 production environment, use XenCenter 8.2.7. For more information, see the XenCenter 8.2.7 documentation.

You can install XenCenter 8.2.7 and XenCenter YYYY.x.x on the same system. Installing XenCenter YYYY.x.x does not overwrite your XenCenter 8.2.7 installation.

When high availability is enabled, some operations that can compromise the plan for restarting VMs might be disabled, such as removing a server from a pool. To perform these operations, you can temporarily disable high availability.

To disable high availability:

  1. Select the pool in the Resources pane, select the HA tab, and then select Disable HA.
  2. Click OK to confirm. The VM startup settings specified for each VM in the pool are stored and remembered if you turn high availability back on again later.
Disable high availability

In this article