XenCenter

Remove a Virtual Network Interface

Note:

XenCenter YYYY.x.x is currently in preview and is not supported for production use. Note that any future references to production support apply only when XenCenter YYYY.x.x and XenServer 8 go from preview status to general availability.

You can use XenCenter YYYY.x.x to manage your XenServer 8 and Citrix Hypervisor 8.2 CU1 non-production environments. However, to manage your Citrix Hypervisor 8.2 CU1 production environment, use XenCenter 8.2.7. For more information, see the XenCenter 8.2.7 documentation.

You can install XenCenter 8.2.7 and XenCenter YYYY.x.x on the same system. Installing XenCenter YYYY.x.x does not overwrite your XenCenter 8.2.7 installation.

You can remove a virtual network interface from a VM without shutting down the VM (“hot unplug”) if the VM meets the following conditions:

  • The VM is not suspended.
  • The VM must have XenServer VM Tools installed.

If one or both of these conditions are not satisfied, shut the VM down before you can remove the virtual network interface.

To remove a virtual network interface:

  1. Select the VM in the Resources pane.
  2. Select the Networking tab.
  3. On the Networking tab, choose the virtual network interface in the list. Click Remove.
Remove a Virtual Network Interface

In this article