Device Location IP Address Template
This template imports a predefined context that defines the location of a remote device based on its IP address, and can be used as a building block in your configuration. It can be found in the
BUILDING BLOCKS category when filtered for REMOTE platform.
deviceTRUST® requires some simple but essential configuration steps to be performed to enable the template for your remoting and DaaS environments. We will guide you step-by-step through simple deviceTRUST configuration steps to enable the template within your remoting or DaaS environment.
We will perform the following steps:
Step 1: Prerequisites
If the required deviceTRUST components (Agent, Console, Client Extension and License) are not yet installed, please visit the Getting Started for Remoteguide and complete step 1 to 5 and then continue here with step 2 below.
Step 2: Context
The template has imported the following context:
| Context | Description | Customizations |
|---|---|---|
| Device Location | Defines the location of a remote device based on its IP address.
`
|
You must update the following context condition with data suitable for your environment |
| REMOTE - NETWORK IPV4 SUBNET IPv4 Range From 1.1.1.1 to 1.1.1.254,...`Replace the IPv4 range for Floor 1, Floor 2, Floor 3,... with the IPv4 range representing the target location. Example: 1.1.1.1 to 1.1.1.254 |
Troubleshooting
If your deviceTRUST installation or configuration does not work as expected, you can use the Troubleshooting guide to start troubleshooting.