XenMobile Server

Enable proxy servers

To control outbound internet traffic, you can set up a proxy server in XenMobile to carry that traffic. You set up a proxy server through the command-line interface (CLI). Setting up the proxy server requires restarting your system.

  1. In the XenMobile CLI main menu, type 2 to select the System menu.

  2. In the System menu, type 6 to select the Proxy Server menu.

    Image of proxy server setup

  3. In the Proxy Configuration menu, type 1 to select SOCKS.

    Before you save this setup, you must also configure HTTPS. The proxy works only if you save the SOCKS and HTTPS settings in the same configuration.

    Image of proxy server setup

  4. Type your proxy server IP address, port number, and target. See the following table for supported target types for each proxy server type.

       
    Proxy type Supported targets
    SOCKS APNS
    HTTP APNS, Web, PKI
    HTTPS Web, PKI
    HTTP with authentication Web, PKI
    HTTPS with authentication Web, PKI

    Image of proxy server setup

  5. Type n and then type 2 to select HTTPS.

  6. Type your proxy server IP address, port number, and target.

  7. If you choose to configure a user name and password for authentication on your proxy server, type y, and then type the user name and password.

    Image of proxy server setup

  8. Type y to save the setup.

Enable proxy servers

In this article